SAFETY NOTICE

If you remember these simple ideas, you can avoid accidents and skate better:

Protective equipment should always be worn.

Wear correct protective equipment - helmet, knee and elbow pads, wrist guards, flat soled shoes, long sleeve tops and trousers which will prevent grazing.

Caution must be used with this skateboard as it requires skill.

Skate in places which allow you to improve your skills. Not on streets and sidewalks, where serious accidents might occur.

Children under 8 years of age should be supervised at all times when skateboarding.

Learn everything slowly, including new tricks.

When loosing balance, do not wait to fall off, step off and start again.

Ride fast where the speed is only as fast as you can step off the board without falling.

Running or jumping onto the RollerSurfer can be dangerous.It is not recommended to skate in or around crowded area.

Learn to fall safely (by rolling if possible) before using the RollerSurfer.

Avoid skating on wet or uneven surfaces.

No modifications should be made to the RollerSurfer which will impair safety.

Even a properly made skateboard needs checking every time before riding, especially the screws, nuts, and wheels - all must be fastened and tightened.

If your wheels wobble, stop riding immediately and check.

From time to time, check all parts for wear, especially wheels - Replace when needed.If you have to replace any component, always replace with the appropriate spare part.

Do not leave the RollerSurfer in damp areas, as this will cause the board to warp.

If bearings tighten or seize, this will probably be due to dirt or grit.

Remember: grit and dirt in the bearings can be dangerous.

Keep your board in good condition - The RollerSurfer should always be clean.